PermanentCoatings.com - Say Goodbye to Painting!



home links site map contact us Permanent Coatings, Victoria BC  
About Us Commercial Residential Benefits Warranty Testimonials Dealership Inquiries IMMCO Specialty Products Ltd - Permanent Coatings, Victoria, BC
Permanent Coatings, a new era in Paint Technology

Products

IMMCO Vinyl Deck Coating

Product ID: 46
Category ID: Industrial Coating
Product Description: Designed as a one component acrylic coating for deck applications. It displays a water resistant and high build film over decks. It is not attacked at normal temperatures by dilute alkalis or mineral acids, alcohol, grease or oils. It has a low moisture-vapour transmission rate, low order of water absorption and is tough and durable.
Colours Available: Pastel, Medium, Deep
Finish: Matte
Vehicle Type: 100% Acrylic Emulsion
Pigment Type: Inert Mineral Pigment
Solvent Type: Water
Flash Point (Min): N/A
Recommended Dry Film: 6-7 mils for first coat, 12-14 after second coat
% Solids by Weight: 65%
Coverage (Theoretical): 400 - 500 ft2/ (18.9 litre pail (Depending on surface porosity).
Viscosity at 77°F (25C): 125-135 Krebs Units
Avg. Drying Time at 77°F (25C): 1/2 Hour to touch, if you need to recoat it again it has to be done while the surface is dry. DO NOT APPLY UNDER DIRECT SUNLIGHT.
Recommended Primers: On most surfaces IMMCO Deck-Coating will act as its own primer, but on very high tannin wood surface (western Red Cedar) IMMCO wood primer is recommended.
Surface Preparation: The surface to receive the coating must be clean and free from all dirt, grease, oil, dust, algae, mildew, fungus and all other surface contaminants that may impair the adhesion and penetration of this product. It is recommended that the substrate be completely dry and have no amount of moisture to obtain best results. Ensure that all new and bare wood is suitably primed with the appropriate primer. Thoroughly clean the surface by pressure washing, sandblasting, sanding, scraping or any other approved method to remove any possible contaminants which will impair adhesion. The use of proper cleaning techniques is strongly recommended to ensure proper application, maximum adhesion and best results.
Application: IMMCO Deck-Coating is supplied as a one component system. Please mix the container thoroughly before use. Do not thin the material with any solvent as this can cause gelling due to interaction with incompatible solvents. IMMCO Deck-Coating can be applied by brush, roller or spray (Best Results).
Additional Info: Consult your IMMCO Speciality products representative for additional information.

^ top