| Product ID: |
46 |
| Category ID: |
Industrial Coating |
| Product Description: |
Designed as a one component acrylic
coating for deck applications. It displays a water resistant and high
build film over decks. It is not attacked at normal temperatures by
dilute alkalis or mineral acids, alcohol, grease or oils. It has a low
moisture-vapour transmission rate, low order of water absorption and is
tough and durable. |
| Colours Available: |
Pastel, Medium, Deep |
| Finish: |
Matte |
| Vehicle Type: |
100% Acrylic Emulsion
|
| Pigment Type: |
Inert Mineral Pigment |
| Solvent Type: |
Water |
| Flash Point (Min): |
N/A |
| Recommended Dry Film: |
6-7 mils for first coat, 12-14 after second coat |
| % Solids by Weight: |
65% |
| Coverage (Theoretical): |
400 - 500 ft2/ (18.9 litre pail (Depending on surface porosity). |
| Viscosity at 77∞F (25C): |
125-135 Krebs Units |
| Avg. Drying Time at 77∞F (25C): |
1/2 Hour to touch, if you need to recoat it again it has to be done while the surface is dry. DO NOT APPLY UNDER DIRECT SUNLIGHT. |
| Recommended Primers: |
On most surfaces IMMCO DeckCote will
act as its own primer, but on very high tannin wood surface (western Red
Cedar) IMMCO wood primer is recommended. |
| Surface Preparation: |
The surface to receive the coating must be clean and
free from all dirt, grease, oil, dust, algae, mildew, fungus and all
other surface contaminants that may impair the adhesion and penetration
of this product. It is recommended that the substrate be completely dry
and have no amount of moisture to obtain best results. Ensure that all
new and bare wood is suitably primed with the appropriate primer.
Thoroughly clean the surface by pressure washing, sandblasting, sanding,
scraping or any other approved method to remove any possible
contaminants which will impair adhesion. The use of proper cleaning
techniques is strongly recommended to ensure proper application, maximum
adhesion and best results. |
| Application: |
IMMCO DeckCote is supplied as a one
component system. Please mix the container thoroughly before use. Do not
thin the material with any solvent as this can cause gelling due to
interaction with incompatible solvents. IMMCO DeckCote can be applied by
brush, roller or spray (Best Results). |
| Additional Info: |
Consult your IMMCO Speciality products representative for additional information. |
